SuperPro Control Arm Lower Complete Alloy Assembly - DuroBall - EA888 MQB Platform (MK7 Golf, S3 8V, MK3 Leon etc) - ALOY0018K
38% Lighter Than OEM
SuperPro Control Arm Lower Complete Alloy Assembly - DuroBall - EA888 MQB Platform (MK7 Golf, S3 8V, MK3 Leon etc) - ALOY0018K
Alloy Arm with DuroBall Rear Bushing and built in Caster Increase - Exclusive to SuperPro
These arms have inbuilt caster and camber change and are designed to move the lower ball joint forward and out to increase the caster by 1 Degree and induce a negative camber change of up to 0.5 Degrees.
These enhancements are the optimal settings over standard to produce a better handling vehicle.
SuperPro has stringently tested these control arms on the Golf 7 GTi, R and Audi A3 RS3 in both standard configuration and with lowered springs.
The sub frame in these vehicles has no positive location and there is a lot of movement allowable in the bolt holes. Therefore, it is critical that sub frame is not misaligned during re-installation. For this reason and for proper clearance it is critical the sub frame be in the most rearward position when torqued up. These arms have not been tested with any aftermarket engine mount packages that may cause a sub frame misalignment and care must be taken.
The recommended lowered front centre of the wheel is 330mm. See fitting instruction for more
Vehicle Applications:
- A3 Mk 3 8V 2WD - 04/2012-on
- A3 Mk 3 8V Quattro - 08/2012-on
- LEON 5F- 09/2012-on
- OCTAVIA 5E - 11/2012-on
- GOLF Mk 7 Typ 5G 4motion - 2012-on
- GOLF Mk 7 Typ 5G FWD - 2012-on
- Handling
- Control Arms & Components
For more in depth information regarding our shipping, returns and refund policies, please refer to our Webstore Terms & Conditions. These can be viewed - Here